Inside diameter
Reconstruct the internal profile from measured points and determine inside diameter through circle fitting.
PIPE-END METROLOGY / pipeMatten
Pipe-end measurementSee the full cross-section.
Inside diameter, outside diameter and local wall thickness, in one circular scan.
Move beyond isolated readings to a fuller dimensional picture.
HOW IT WORKS · INTERACTIVE 3D
One measurement instrument.
Two support configurations.
See support, positioning and rotating measurement through a transparent pipe. Switch configurations to explore the different workflows.
Ready3D workflow illustration
Inner surfaceOuter surface
Loading the 3D instrument
0°0 / 1440illustrated sample points
From pipe end
Drag to orbit · Scroll to zoom · Animation timing is illustrativeExpand, support and scan.
Twin screws drive the scissor supports to raise the instrument. Once supported and positioned, the head performs a circular scan.
Outside diameter
Determine dimensions from the measured outer profile, rather than substituting nominal dimensions.
Local wall thickness
Review wall thickness around the section, including minimum, mean and maximum values.
MEASUREMENT
Stationary pipe.
Rotating measurement head.
Angle and distance data describe the cross-section. Two sensors observe the inner and outer surfaces to support pipe-end inspection, process checks and matching analysis.
360°Full circular scan
1440Data pairs per rotation
0.25°Angular output increment
20 / 100mmMeasurement sections
WORKFLOW
From reference to results.
Operate from the tablet.
- 01
Connect and calibrate
Connect the tablet wirelessly and establish the measurement reference with a suitable calibration ring.
- 02
Support and position
Prepare the selected support configuration and position the head at the required section.
- 03
Scan and review
Start a circular scan from the tablet and review diameter and wall-thickness results.
WIRELESS CONTROL · BATTERY POWER
Keep the data.
Simplify operation.
Connect over Wi-Fi for calibration, scanning and result review. The tablet brings the section profile and key dimensions together in one place.
Pipe-end measurement● Wi-Fi
360°
Fitted ID—mmOutside diameter—mmWall min / mean / max— / — / —
Start scanCalibrate
CONFIGURATION
Choose the support.
Configure the measurement.
Select sensors, supports and calibration for the required dimensions, section locations and operating conditions.
For adjustable support requirements
Powered expansion and retraction reduce manual support adjustment. The modular configuration shares the measurement and control workflow.
For repeated, stable-size applications
Fixed support geometry without a lift drive. Placement and axial repositioning are manual; the support remains unchanged during scanning.
FAQ
Frequently asked questions
How do the two supports differ?＋
Automatic supports expand and retract through a drive mechanism. Fixed supports retain their configured geometry for repeated measurements within a stable application. Both use a rotating measurement head.
Do fixed supports move automatically?＋
No. Placement and withdrawal in the fixed-support animation represent manual handling. The support legs do not extend or retract.
Which sections can be measured?＋
Sections 20 mm or 100 mm from the pipe end are shown. Each scan covers one section; the application defines the final configuration and positioning.
Is nominal wall thickness needed for measurement?＋
Wall thickness is obtained from measured data, not nominal values. The selected sensor range, support configuration and calibration must suit the part.
How are range and accuracy specified?＋
Sensor and support configurations are selected for dimensions, section location, surface condition and operating cycle, with corresponding calibration and acceptance requirements.
START WITH YOUR APPLICATION
Find the right
pipe-end measurement configuration.
Tell us the dimensions, section location and accuracy requirement.
Configure the measurement around your application.